Monitored & Set Conditions
WARNING: This page is about a different car, the 2004 Chrysler Intrepid, 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
Circuit is monitored in 2 tests. Test No. 1: Vehicle speed must be greater than 20 MPH to enable. TEST No. 2: Speed must be zero MPH and brake switch indicate on. DTC will set in Test No. 1 if vehicle speed goes to zero MPH without brake input. Condition must be repeated 15 times to set fault. DTC will set in Test No. 2 if vehicle speed goes above 20 MPH for more than 6.0 seconds without a change in brake state. Condition must be repeated 15 times to set fault. This is a two trip fault.