Monitored & Set Conditions
WARNING: This page is about a different car, the 2004 Chrysler Intrepid, 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
Ignition coil primary circuit is monitored with battery voltage greater than 11 volts, with engine RPM at less than 8160 RPM, and no coils in dwell when checked. DTC will set if PCM senses peak current is not achieved with battery based dwell plus 1.5 milliseconds of diagnostic offset. DTC takes less than 3 seconds to set with engine cranking, or up to 6 seconds with engine running. This is a one trip fault.