Test 4A - Driver Squib Circuit Shorted
WARNING:
Disconnect battery and wait 2 minutes before proceeding.
- Disconnect battery and wait 2 minutes. Disconnect driver-side air bag module. Turn ignition on. Reconnect battery. Use DRB to read active codes. If DRB shows DRIVER SQUIB CIRCUIT OPEN, replace driver-side air bag module. If not, go to next step.
- Disconnect clockspring 2-way connector. Use DRB to read active codes. If DRB shows DRIVER SQUIB CIRCUIT OPEN, replace clockspring. If not, go to next step.
- Disconnect battery and wait 2 minutes before proceeding. Disconnect ACM 4-way connector. Turn ignition on. Reconnect battery. Use DRB to read active codes. If DRB shows DRIVER SQUIB CIRCUIT OPEN, repair driver-side air bag line 1 short to driver-side air bag line 2. If not, perform TEST 15A - ACM REPLACEMENT PROCEDURE .