Test 11A - Passenger-Side Squib Circuit Shorted
WARNING:
Disconnect battery and wait 2 minutes before proceeding.
- Disconnect passenger-side air bag module. Turn ignition on, then reconnect battery. Use DRB to read active codes. If DRB shows PASSENGER SIDE SQUIB OPEN, replace passenger-side air bag module. If not, disconnect battery and wait 2 minutes before proceeding.
- Disconnect air bag control module 4-way connector. Disconnect passenger-side air bag line 1 (CAV 1) at ACM 4 way connector. Do not remove or damage shorting bar. Use ohmmeter to measure resistance between passenger air bag line 1 and line 2 at passenger air bag 2-way connector. If resistance is above 5.0 ohms, repair passenger-side air bag line 1 circuit short to line 2. If resistance is below 5.0 ohms, perform TEST 15A - ACM REPLACEMENT PROCEDURE .