Instrument Panel - Analog: Testing: Self-Diagnostics

Press and hold TRIP RESET button while turning ignition switch to OFF/RUN/START positions. This will cycle an electronic display segment check and illumination in sequence of all CCD bus activated warning indicators. There are 4 check functions:

• CHECK 1 (Gauge Display Check)  If all gauges fail to move, replace printed circuit. If any gauge fail to move, replace gauge assembly. If any gauge is not in proper position, replace printed circuit.
• CHECK 2 (Warning Light Display Check)  If any light does not light, check bulb. If bulb is okay, replace printed circuit.
• CHECK 3 (Vacuum Fluorescent (VF) Display Check)  If any VF segment does not light, replace odometer/transmission range indication.
• CHECK 4 (Transmission Range VF Display, A/T Check)  If any VF segment does not light, replace odometer/transmission range indication. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION.