LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1988 >> Caravan Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.2L 4-CYL - VIN [C] & 2.5L 4-CYL - VIN [K] >> Overhaul >> Piston & Rod Assembly >> Fitting Rings

Fitting Rings

Place cylinder block upside down. Position ring in bore in which it will be used. Using head of piston, push ring into bore approximately .62" (16 mm) from bottom. Substitute another ring set if gaps are not within specification.

CAUTION: Use care to avoid damage to ring or cylinder bore.
scientia non olet · About LEMON Manuals