LEMON Manuals: Even more car manuals for everyone
Home >> Daewoo >> 2000 >> Nubira SE, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rotor - Front Disc Brake >> Removal & Installation

Removal & Installation

  1. Remove caliper. Remove brake pads. Remove caliper mounting bracket. Remove rotor detent screw. Remove rotor.
    NOTE: To guarantee uniform braking, always refinish both rotors even if only one rotor is defective. If a rotor is being replaced, use a new rotor on both skies of vehicle.
  2. Install rotor on front wheel hub and install detent screw. Tighten rotor detent screw to 4 N.m (35 INCH lbs.). Apply a few drops of thread-locking compound to bolts and install caliper bracket.
  3. Tighten caliper bracket-to-steering knuckle mounting bolts to 95 N.m (70 ft. lbs.). Install brake pads and caliper.
scientia non olet · About LEMON Manuals