LEMON Manuals: Even more car manuals for everyone
Home >> Daewoo >> 2000 >> Leganza CDX >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.2L DOHC >> Removal & Installation >> Camshafts >> Removal

Removal & Installation: Camshafts: Removal

NOTE: Take extreme care to prevent any scratches, nicks, or damage to camshafts.
  1. Remove timing belt. Disconnect breather tube at valve cover. Disconnect crankcase ventilation tube at valve cover. Remove spark plug cover bolts. Remove spark plug cover. Disconnect ignition wires from spark plugs.
  2. Disconnect camshaft position (CMP) sensor connector. Remove valve cover bolts. Remove valve cover washers. Remove valve cover and valve cover gasket. While holding intake camshaft firmly in place, remove intake camshaft gear bolt.
  3. Remove intake camshaft gear. While holding exhaust camshaft firmly in place, remove exhaust camshaft gear bolt. Remove exhaust camshaft gear. Loosen camshaft bearing cap bolts in stages of one-half to one turn.
  4. Remove camshaft bearing cap bolts from cylinder head. See Fig 1. Remove camshafts. Remove seal ring from camshafts. Check camshaft and bearing seats for wear and replace them if necessary.
    NOTE: The camshaft must detach evenly from bearing seats in front guide bearing.
    Fig 1: Camshaft Bearing Caps
    G00043929Courtesy of DAEWOO MOTOR AMERICA, INC.
scientia non olet · About LEMON Manuals