LEMON Manuals: Even more car manuals for everyone
Home >> Daewoo >> 2000 >> Leganza CDX >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.2L DOHC >> Removal & Installation >> Camshaft Gears >> Installation

Camshaft Gears: Installation

NOTE: Take extreme care to prevent any scratches, nicks, or damage to camshafts.
  1. Install intake camshaft gear. While holding intake camshaft firmly in place, install intake camshaft gear bolt. Tighten intake camshaft gear bolt to 50 N.m (37 ft. lbs.). Using angular torque gauge, tighten bolt an additional turn of 60 degrees, plus another turn of 15 degrees. Install exhaust camshaft gear.
  2. While holding exhaust camshaft firmly in place, install exhaust camshaft gear bolt. Tighten exhaust camshaft gear bolt to 50 N.m (37 ft. lbs.). Using angular torque gauge, tighten bolt an additional turn of 60 degrees, plus another turn of 15 degrees. Apply a small amount of gasket sealant to corners of front camshaft caps and to top of rear valve cover-to-cylinder head seal. Install valve cover and valve cover gasket.
  3. Install valve cover washers. Install valve cover bolts. Tighten valve cover bolts to 8 N.m (71 INCH Lbs.). Connect crankcase breather tubes to valve cover. Connect ignition wires to spark plugs. Install spark plug cover. Install spark plug cover bolts. Tighten spark plug cover bolts to 3 N.m (27 INCH Lbs.). Install timing belt. Connect negative battery cable.
scientia non olet · About LEMON Manuals