LEMON Manuals: Even more car manuals for everyone
Home >> Daewoo >> 2000 >> Leganza CDX >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc >> Removal & Installation >> Parking Brake Cable >> Installation

Parking Brake Cable: Installation

  1. Route parking brake cable to protruding hole on rear knuckle assembly. Fasten parking brake cable to lever at rear of disc brake backing plate.
  2. Install clip that secures parking brake cable to protruding hole on rear knuckle assembly. Install bolt securing parking brake cable to a holding bracket, attached to trailing link bracket on both driver and passenger sides of vehicle. Tighten parking brake cable bracket-to-trailing link bracket nuts to 90 N.m (66 ft. lbs.).
  3. Install nut that secures parking brake cable to bracket near fuel tank strap (passenger and driver sides). Tighten parking brake cable nut to 12 N.m (106 INCH lbs.). Route parking brake cables through access holes to parking brake/gearshift console.
  4. Install rubber grommet for each cable. Install front muffler heat shield. Tighten front muffler heat shield nuts to 2.5 N.m (22 INCH lbs.). Route parking brake cable through console-to-underbody mounting bracket and secure bracket with nuts. Tighten parking brake cable console mounting bracket nuts to 25 N.m (18 ft. lbs.).
  5. Install rear wheels. Lower vehicle. Attach parking brake cable ends to equalizer. Install parking brake-gearshift console hood. Install screws and washers securing keyless entry receiver to underbody bracket. Tighten keyless entry receiver screws to 10 N.m (89 INCH lbs.).
scientia non olet · About LEMON Manuals