Diagnostic Test

CHECK FOR ACTIVE DTCS 

1. With the scan tool, record and erase the DTCs.
2. Cycle the ignition off, wait 10 seconds, then cycle the ignition on.
3. With the scan tool, read the Active DTCs.

   Does the scan tool display; B224F-96 DOOR MODULE INTERNAL-COMPONENT INTERNAL FAILURE?

   Yes 

   • Replace the Right Rear Door Module in accordance with the Service Information. Refer to MODULE, DOOR (DDM/PDM), REMOVAL AND INSTALLATION and/or MODULE, DOOR, POWER SLIDING (PSDML/PSDMR), REMOVAL AND INSTALLATION .
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

   No 

   • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and poor pin fit.
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .