LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2025 >> Pacifica Plug-In Hybrid Select >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Audio (Radio) (RRM) - DTCS B140C-12 To B1579-1A) >> DTC Troubleshooting >> B156B-01 Satellite Radio Antenna-General Electrical Failure >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2025 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK THE ANTENNA CONNECTION 
    1. Turn the ignition off.
    2. Disconnect the Satellite Radio Antenna connections.
    3. Inspect the Satellite Radio Antenna connections.

      Are the Antenna connections clean and secure?

      Yes 

      • Go To  2

      No 

      • Repair the Antenna connection as needed.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  2. CHECK THE ANTENNA AND CABLE 
    1. Connect the Radio Diagnostic Tool to the Satellite Antenna connection on the back of the Radio.

      (special tool #9977-6-SAT, Antenna)

      GC0214825Courtesy of CHRYSLER GROUP, LLC
    2. Make sure one of the front doors is still open.
    3. Using the scan tool, erase DTCs.
    4. Turn the ignition on.
    5. Turn the Radio on.
    6. Using the scan tool, read Radio DTCs.
      NOTE:

      While using the 9977-6-SAT test antenna the GPS reception will not be available and GPS faults may occur. The 9977-6-SAT test tool will only enable satellite radio reception to work. For GPS reception concerns use test antenna 9977-6-GPS-GLO. 

      Is the DTC active?

      Yes 

      No 

      • Go To  3
  3. TEST THE SATELLITE ANTENNA CABLE 
    1. Disconnect the Satellite Antenna cable at the Satellite Antenna.
    2. Connect the appropriate Radio Diagnostic Tool to the Satellite Antenna cable at the back of the Radio.

      (special tool #9977-6-1, Adapter)

      GC0214830Courtesy of CHRYSLER GROUP, LLC

      (special tool #9977-6-3, Adapter)

      GC0214828Courtesy of CHRYSLER GROUP, LLC
    3. Connect the appropriate Radio Diagnostic Tool to the Satellite Antenna cable at the Satellite Antenna.

      (special tool #9977-6-4, Jumper)

      GC0214827Courtesy of CHRYSLER GROUP, LLC

      (special tool #9977-6-2, Jumper)

      GC0214829Courtesy of CHRYSLER GROUP, LLC
    4. Measure the Resistance across the terminals on the tool.

      Is the resistance below 47.5 Ohms?

      Yes 

      • Use the Radio Diagnostic Tool (special tool #9977-6, Kit, Radio Antenna Diagnostic) to locate and repair or replace the Satellite Antenna cable as necessary.
        GC0214818Courtesy of CHRYSLER GROUP, LLC
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No