Diagnostic Test

CHECK FOR AN ACTIVE DTC 

1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. NOTE: The Radio must be on. 

   NOTE: A front door must remain open whenever checking or erasing RADIO DTCs. 

3. With the scan tool, run a Vehicle Scan Report, or record the Environmental Data related to the DTCs.
4. With the scan tool, perform an ECU reset to the Radio, and then erase DTCs.
5. Turn the ignition off for a minimum of 10.0 seconds.
6. Turn the ignition on.
7. Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
8. With the scan tool, read DTCs.
   NOTE:

   Make sure the Radio is turned on. 

   NOTE:

   A front door must remain open whenever checking or erasing RADIO DTCs. 

   Did the DTC return?

   Yes 

   • Replace the Rear Camera Module in accordance with the Service Information.
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

   No 

   • Perform the TESTING FOR AN INTERMITTENT CONDITION diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .