Diagnostic Test

Check For An Active DTC
1. Turn The Ignition On And Open One Of The Front Doors.
  NOTE:
  A Front Door Must Remain Open Whenever Checking Or Erasing Radio DTCS.
2. With The Scan Tool, Perform An ECU Reset To The Radio, And Then Erase DTCS.
3. Turn The Ignition Off For A Minimum Of 10.0 Seconds.
4. Turn The Ignition On.
5. With The Scan Tool, Read Radio DTCS.
  Did The DTC Return?
  
  Yes
  - Go To 2
  No
  - Perform The Testing For An Intermittent Condition Procedure. Refer To Testing For An Intermittent Condition .
Check The Antenna Connection
1. Turn The Ignition Off.
2. Disconnect The FM2 Diversity Antenna Connector At The Back Of The Radio.
3. Inspect The FM2 Diversity Antenna Connections.
  Are The Antenna Connections Clean And Secure?
  
  Yes
  - Go To 3
  No
  - Repair The Antenna Connection As Needed.
  - Perform The Body Verification Test. Refer To Body Verification Test .
Check The Antenna And Cable
1. Connect The (Special Tool #9977-6-Fm, Antenna) To The Antenna Connection On The Back Of The Radio.
2. Make Sure One Of The Front Doors Is Still Open.
3. Turn The Ignition On.
4. With The Scan Tool, Perform An ECU Reset To The Radio, And Then Erase DTCS.
5. Turn The Ignition Off For A Minimum Of 10.0 Seconds.
6. Turn The Ignition On.
7. Turn The Radio On.
8. With The Scan Tool, Read Radio DTCS.
  Is The DTC Active?
  
  Yes
  - Replace The Radio In Accordance With The Service Information. Refer To Module, Radio Receiver, Removal And Installation .
  - Perform The Body Verification Test. Refer To Body Verification Test .
  No
  - Go To 4
Test The Antenna Cable
1. Disconnect The Antenna Cable At The Base.
2. Connect The Appropriate (Special Tool #9977-6-1, Adapter) Or (Special Tool #9977-6-3, Adapter) To The Antenna Cable At The Back Of The Radio.
3. Connect The Appropriate (Special Tool #9977-6-4, Jumper) Or (Special Tool #9977-6-2, Jumper) To The Antenna Cable At The Antenna Base.
4. Measure The Resistance Across The Tool Terminals.
  Is The Resistance Above 52.5 Ohms?
  
  Yes
  - Use The (Special Tool #9977-6, Kit, Radio Antenna Diagnostic) To Locate The Open Circuit, Repair Or Replace The Antenna Cable As Necessary.
  - Perform The Body Verification Test. Refer To Body Verification Test .
  No
  - Replace The Antenna Base In Accordance With The Service Information.
  - Perform The Body Verification Test. Refer To Body Verification Test .