Diagnostic Test

Read And Record DTCS And Environmental Data - Erase DTCS And Check For DTC To Return
1. With The Scan Tool, Read DTCS In All Electronic Control Units (ECUS) And Record On The Repair Order.
2. With The Scan Tool, Run A Vehicle Scan Report, Or Record The Environmental Data Related To The DTCS.
3. With The Scan Tool, Erase All DTCS.
4. Turn The Ignition Off For A Minimum Of 10.0 Seconds.
5. Turn The Ignition On.
6. Using The Recorded Environmental Data And The When Monitored Conditions Above, Operate The Vehicle In The Conditions That Set The DTC.
7. With The Scan Tool, Read DTCS.
Did The DTC Return?

Yes
- Go To 2
No
- Perform The Appropriate Intermittent Condition Diagnostic Procedure. Refer To Testing For An Intermittent Condition .
Verify Operation Of The SOS/Emergency Call Button
NOTE:
From The Pre-Diagnostic Troubleshooting Procedure, All Communication Related Dtc's To The Overhead Console Switch And Body Control Module Are To Be Corrected Before Proceeding With This Diagnostic Testing.

NOTE:
Make Sure That The SOS/Emergency Call Button Is Free Of Debris.
1. With The Scan Tool, Read Radio DTCS And Record On Repair Order.
2. With The Scan Tool, Erase DTCS.
3. Press And Release The SOS/Emergency Call Button Three Times.
4. Wait 60 Seconds.
5. With The Scan Tool, Read DTCS.
  Did The DTC Return?
  
  Yes
  - Replace The Switch In Accordance With The Service Information.
  - Perform The Body Verification Test. Refer To Body Verification Test .
  No
  - Test Complete.
  - Perform The Body Verification Test. Refer To Body Verification Test .