LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2020 >> 300 C >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (8HP50/850RE Automatic Transmission (Service Information)) >> Standard Procedure >> Clutch D Measurement

Clutch D Measurement

WARNING: This page is about a different variant/trim than selected.
GC0154393Courtesy of CHRYSLER GROUP, LLC
  1. Using (special tool #8901A, Pressing Tool) (3) and (special tool #10429, Gauge, Force) (1) place clutch D in a suitable arbor press.
  2. Apply 200 N (45 lbs.) of force to the clutch D backing plate to compress the wave plate.
  3. With a suitable feeler gauge, measure the gap (2) between the clutch D backing plate and the clutch D retainer.
  4. Refer to clutch clearance table for specs. Refer to TECHNICAL SPECIFICATIONS . If clearance is not within specification a thinner or thicker selectable snap ring can be Installed to achieve proper clearance.
scientia non olet · About LEMON Manuals