Clutch B Measurement
WARNING: This page is about a different variant/trim than selected.
When clutch B is replaced, the proper selectable shim must be installed to achieve specified clearance.
Measurement ,
- Place clutch B, with the wave plate (1) on top, on a suitable arbor press.
- Position tools (special tool #8901A, Pressing Tool) (3) (using just the cross bar) and (special tool #10429, Gauge, Force) (2) on top of the clutch B wave plate (1) and under the press ram.
- Apply 500 N (112 lbs.) of downward force on clutch B to compress the wave plate.
- Using a suitable micrometer, measure the thickness of the compressed clutch B. Record the measurement as (A)
to calculate the clutch B clearance in order to determine the correct selectable shim thickness.
- With a suitable depth micrometer, place it at the mounting surface of the transmission oil pump (2) and measure to the base of the clutch B retainer on the case (1). This measurement should be 61.05 mm. Record the measurement as (B)
to calculate the clutch B clearance in order to determine the correct selectable shim thickness.
- Using a suitable depth micrometer, measure the clutch B piston.
- Measure between the fluid pump sealing surface and the bottom of the straight edge. Record the measurement as (C) to calculate the clutch B clearance in order to determine the correct selectable shim thickness.
Calculation
Take the case depth (B), subtract (C) and then subtract (A). The remainder is the clearance of clutch B. If the clearance is not within specification a thinner or thicker reaction plate can be installed to achieve proper clearance. Refer to TECHNICAL SPECIFICATIONS .