LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2020 >> 300 C >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (8HP50/850RE Automatic Transmission (Service Information)) >> Seal, Output Shaft >> Installation >> Rear Wheel Drive

Rear Wheel Drive

WARNING: This page is about a different variant/trim than selected.
CAUTION:

The seal must be installed flush with the case. Driving the seal deeper could damage the seal causing a leak.

  1. Position the new output shaft seal over the output shaft and against the transmission case.
  2. Using (special tool #8481, Installer, Gear) install the output shaft seal.
  3. Verify that the transmission is in PARK in order to prepare for the installation of the output shaft nut.
  4. Install the driveshaft flange onto the output shaft and install an NEW  flange nut. Tighten the nut, with a 34 mm 12 point socket, to. Refer to TECHNICAL SPECIFICATIONS .
  5. Stake the nut.
  6. Install the driveshaft.
  7. Perform the CHECK OIL LEVEL procedure. Refer to STANDARD PROCEDURE - CHECK OIL LEVEL  .
scientia non olet · About LEMON Manuals