Clutch, D: Disassembly

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

1. Friction plate

2. Backing plate

3. Backing plate

4. Wave plate

Place clutch D (3) in a suitable arbor press (1).
Using (special tool #8901A, Pressing Tool) (4), compress the oil baffle (2) enough the clear the locking tabs.

Courtesy of CHRYSLER GROUP, LLC

Courtesy of CHRYSLER GROUP, LLC
Rotate the oil baffle (2) slightly until the tabs on the hub are clear of the baffle.

Courtesy of CHRYSLER GROUP, LLC
Remove the oil baffle (2).

Courtesy of CHRYSLER GROUP, LLC
Remove the belleville spring (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the selective snap ring (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the clutch D backing plate (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the clutch D (3) frictions (1) and steels (2), paying attention to the orientation.

Courtesy of CHRYSLER GROUP, LLC
Remove the clutch D piston (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the clutch D carrier seal rings (2).

Courtesy of CHRYSLER GROUP, LLC