LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2020 >> 300 C >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (BW44-40 Transfer Case (Service Information)) >> Seal, Output Shaft >> Removal >> Rear

Seal, Output Shaft: Removal: Rear

WARNING: This page is about a different variant/trim than selected.
  1. Remove the rear driveshaft. Refer to REMOVAL REAR .
    GC0095862Courtesy of CHRYSLER GROUP, LLC
  2. Install (special tool #6958, Wrench, Spanner) Spanner Wrench (1) onto the rear output flange (2).
  3. Remove the rear output flange nut.
    GC0095863Courtesy of CHRYSLER GROUP, LLC
  4. Remove the rear output flange washer (1).
    GC0095864Courtesy of CHRYSLER GROUP, LLC
  5. Remove the outer rear output shaft seal (1).
    GC0095865Courtesy of CHRYSLER GROUP, LLC
  6. Remove the rear output flange (1).
  7. Remove the rear output seal.
scientia non olet · About LEMON Manuals