LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2020 >> 300 C >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (BW44-40 Transfer Case (Service Information)) >> Fluid >> Standard Procedure >> Standard Procedure - Fluid Check

Standard Procedure - Fluid Check

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0095857Courtesy of CHRYSLER GROUP, LLC
  2. Clean the area around the transfer case fill (3) and drain plugs (2).
    NOTE:

    Inspect all the transfer case plug seals and replace as necessary.

  3. Remove the transfer case fill plug (3).
  4. Remove the transfer case drain plug (2) and allow the transfer case lubricant to drain into a suitable container.
  5. When the fluid has stopped draining, install the drain plug (2) and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  6. Using the fill hole (3), fill the transfer case with 1.0 L +/- 0.05 L (2.11pint +/- 0.11 pint) of fluid. Refer to CAPACITIES AND RECOMMENDED FLUIDS, SPECIFICATIONS .
  7. Install the fill plug (3) and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
scientia non olet · About LEMON Manuals