LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2020 >> 300 C >> Repair and Diagnosis >> Electrical >> Gauges >> Body - Interior & Exterior >> Doors - Rear >> Handle, Exterior >> Removal

Handle, Exterior: Removal

multimedia:A supplement to the article is available.
NOTE:

Front shown in illustration, Rear similar.

GC0170912Courtesy of CHRYSLER GROUP, LLC
NOTE:

LH Shown in illustration, RH typical.

  1. Disconnect the negative battery cable.
  2. Remove the protective plug used to cover the PIA fastener (2) located rearward of the door lock cylinder/delete cap (1).
  3. Using a suitable tool, turn the screw counter-clockwise to move the slide plate forward in the outside door handle bracket. Continue to turn the screw while lightly pulling on the door handle cap (1), until the cap is removed. Then turn the screw clockwise to move the slide pate rearward away from the lever. Do not attempt to remove the PIA fastener. 
  4. Pull the handle out slightly; then turn the screw counterclockwise until the slide plate intersects the lever.
    GC0144868Courtesy of CHRYSLER GROUP, LLC
  5. Slide handle (1) rearward and out.
  6. Disconnect the harness connector and remove the handle (1).
scientia non olet · About LEMON Manuals