LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2019 >> 300 C >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Controls >> Sensor, Humidity >> Removal

Sensor, Humidity: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    NOTE:

    The rearview mirror does not have to be removed to service the humidity sensor.

  2. Remove the upper and lower rearview mirror trim. Refer to MIRROR, REARVIEW, REMOVAL .
    GC0144744Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Use care when removing the humidity sensor. The humidity sensor bracket cannot be serviced separately from the windshield. If the sensor bracket becomes damaged, the windshield will need to be replaced.

  3. Using a small screwdriver or similar tool, carefully disengage the metal retaining clip (3) from the sensor bracket (2) and remove the humidity sensor (4) and the clip as an assembly.
  4. Disconnect the wire harness connector (1) from the humidity sensor.
  5. If the humidity sensor bracket is damaged and cannot be reused, replace the windshield. Refer to WINDSHIELD, REMOVAL .
scientia non olet · About LEMON Manuals