LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2019 >> 300 C >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lamps/Lighting - Exterior (Service Information) >> Smart Beam >> Standard Procedure >> Vehicle Preparation For SMARTBEAM® Calibration

Vehicle Preparation For SMARTBEAM® Calibration

  1. Be certain that the imager lens and the windshield glass in front of the imager lens are clean and free from obstructions.
  2. Be certain that the inside rear view mirror mounting is properly tightened and secure.
  3. Repair or replace any ineffective, worn or damaged suspension components that could hinder proper SmartBeam® calibration.
  4. Verify proper tire inflation pressures.
  5. Remove any accumulations of mud, snow or ice from the vehicle underbody.
  6. Verify that there is no load in the vehicle (cargo or passengers), except for the driver.
  7. The fuel tank should be FULL. Add 2.94 kilograms (6.5 pounds) of weight over the fuel tank for each estimated gallon of missing fuel.
  8. Verify correct vehicle suspension height.
  9. Verify that the vehicle has at least 16 kilometers (10 miles) showing on the odometer.
scientia non olet · About LEMON Manuals