Fascia, Rear: Removal

Courtesy of CHRYSLER GROUP, LLC

Disconnect the negative battery cable.
Raise and support the vehicle.
Remove the lower nuts (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the three push-pin retainers that secure each rear wheel house splash shield to the rear fascia assembly and position aside the splash shield.
Remove the fastener (1) that secures the rear fascia assembly to the rear quarter.
Pull down on the end of the bracket (2) to allow the fascia to be pulled out.
Remove the fasteners (3) that secures the rear fascia assembly to the rear fascia support bracket.

Courtesy of CHRYSLER GROUP, LLC
Pull out on the fascia (2) at the wheel house opening to disengage the fascia from the retaining bracket (1). Repeat on the opposite side.

Courtesy of CHRYSLER GROUP, LLC
Release the fascia (2) from the rear retaining bracket (1) under the tail lamp assemblies. Do not completely remove at this time.

Courtesy of CHRYSLER GROUP, LLC
With the help of an assistant, pull rearward to release the fascia (4) from the support (1).
Disconnect the marker light electrical connectors (2) and the park assist harness.
With the help of an assistant, remove the fascia (1) from the vehicle.