LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2018 >> 300 C >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lamps/Lighting - Interior (Service Information) >> Switch, Dimmer >> Removal

Switch, Dimmer: Removal

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

  1. Disconnect and isolate the battery negative cable.
  2. Remove Steering Column Opening Cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL .
    GC0144598Courtesy of CHRYSLER GROUP, LLC
  3. Remove the three screws that secure the dimmer module to the back of the instrument panel trim molding.
  4. Remove the dimmer module from the trim molding.
scientia non olet · About LEMON Manuals