P0340-Camshaft Position Sensor Circuit - Bank 1 Sensor 1: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
The CMP sensor is a dual read sensor reading both camshafts of it's correlating bank.
| 3.6L VVT Component Locations | ||
|---|---|---|
| CALLOUT | DESCRIPTION | |
| 1 | VVT Actuator Bank 1 Position 1 (Intake) | |
| 2 | VVT Actuator Bank 1 Position 2 (Exhaust) | |
| 3 | VVT Actuator Bank 2 Position 1 (Intake) | |
| 4 | VVT Actuator Bank 2 Position 2 (Exhaust) | |
| 5 | Bank 1 Camshaft Sensor | |
| 5A | CMP Bank 1 Sensor 1 (Exhaust) | |
| 5B | CMP Bank 1 Sensor 2 (Intake) | |
| 6 | Bank 2 Camshaft Sensor | |
| 6A | CMP Bank 2 Sensor 1 (Exhaust) | |
| 6B | CMP Bank 2 Sensor 2 (Intake) | |
For a complete wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAMS article .