LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2012 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (6.4L Engine (Service Information)) >> Engine Block >> FLEXPLATE >> Installation >> Installation

Engine Block: FLEXPLATE: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Flex Plate Bolt Removal/Tightening Sequence
GC0095614Courtesy of CHRYSLER GROUP, LLC
  1. Position the flexplate (1) onto the crankshaft and install the bolts finger tight.
  2. Using the sequence shown in illustration, tighten the flexplate retaining bolts to 95 N.m (70 ft. lbs.).
  3. Install the transmission. Refer to INSTALLATION .
scientia non olet · About LEMON Manuals