Damper, Vibration: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Negative Battery Cable

Courtesy of CHRYSLER GROUP, LLC

Disconnect the negative battery cable (1).
Drain the cooling system. Refer to STANDARD PROCEDURE .

Fig 2: Upper Radiator Hose, Clamp, Oil Cooler Return Line Hose & Clamp
Courtesy of CHRYSLER GROUP, LLC
Remove the upper radiator hose clamps (1) and remove the upper radiator hose (2).
Remove the oil cooler hose clamp (3) and remove oil cooler hose (4) and position aside.

Fig 3: Identifying Accessory Drive Belt, Tensioner & Pulleys
Courtesy of CHRYSLER GROUP, LLC
Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .

Fig 4: Cooling Fan Electrical Connector, Bolts & Radiator Cooling Fan Assembly
Courtesy of CHRYSLER GROUP, LLC
Remove the cooling fan assembly. Refer to FAN, COOLING, REMOVAL .

Fig 5: Vibration Damper & Bolt Grip Puller
Courtesy of CHRYSLER GROUP, LLC

NOTE:
When installing the puller tool, ensure the bolts are fully threaded through the entire crankshaft damper.
Remove the vibration damper bolt.
Install the puller tool (2) making sure the bolts are fully threaded through the entire crankshaft damper.
Remove the crankshaft damper (1).