LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2012 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (6.4L Engine (Service Information)) >> Air Intake System >> Body, Air Cleaner >> Installation >> Installation

Body, Air Cleaner: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Air Duct Retaining Clamp, Intake Air Temperature Sensor Electrical Connector, Makeup Air Hose, Bolt & Air Cleaner Housing
GC0148444Courtesy of CHRYSLER GROUP, LLC
  1. While sliding the air duct onto the throttle body, lower the air cleaner housing (5) into position and align the locating pin on the bottom of the housing.
  2. Install the air cleaner housing retaining bolt (4) and tighten to 5 N.m (44 in. lbs.).
  3. Install the makeup air hose (3) at the air cleaner housing.
  4. Connect the intake air temperature sensor electrical connector (2).
  5. Position the air duct retaining clamp (1) at the throttle body and tighten to 3 N.m (30 in. lbs.).
scientia non olet · About LEMON Manuals