Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR BCM CAN BUS DTCS
- With the scan tool, read BCM DTCs.
Are any BCM CAN BUS DTCs present?
Yes
- Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure. Perform the diagnostic procedure for DTC U0001-CAN C BUS first.
- Refer to STANDARD PROCEDURE and perform the TRANSMISSION VERIFICATION TEST.
No
- Go To 2.
- With the scan tool, read BCM DTCs.
- CHECK IF ENGINE DTCS ARE PRESENT
- With the scan tool, read engine DTCs.
Are any engine DTCs present?
Yes
- Refer to DTC INDEX and perform the appropriate diagnostic procedure.
- Refer to STANDARD PROCEDURE and perform the TRANSMISSION VERIFICATION TEST.
No
- Using the schematics as a guide, check the Transmission Control Module A (TCMA) terminals for corrosion, damage or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCMA in accordance with the Service Information. Refer to VALVE BODY, REMOVAL .
- Refer to STANDARD PROCEDURE and perform the TRANSMISSION VERIFICATION TEST.
- With the scan tool, read engine DTCs.