Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK DTC IS CURRENT
1. Turn the ignition ON.
2. With the scan tool, CLEAR transmission DTCs.
3. Start the engine.
4. Allow the engine to reach normal operating temperature.
5. With the scan tool, select View DTCs.
  NOTE:
  It may be necessary to drive the vehicle to meet the conditions to set this DTC, try to repeat the conditions in which the fault set by reviewing the Freeze Frame data.
  
  Is the DTC Active at this time?
  
  Yes
  - Replace the transmission in accordance to the Service Information. Refer to REMOVAL .
  No
  - Check the transmission fluid level and condition. Refer to FLUID AND FILTER, STANDARD PROCEDURE .
  - Refer to STANDARD PROCEDURE and perform the TRANSMISSION VERIFICATION TEST.