Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK DTC IS CURRENT
1. Turn the ignition ON.
2. With the scan tool, CLEAR Transmission DTCs.
3. Raise the vehicle on the hoist.
4. Start the engine.
5. With the scan tool, monitor the Input Speed Sensor RPM.
6. Firmly apply the brake pedal and place the gear selector in Drive.
  WARNING:
  To avoid personal injury or death, keep hands and feet clear of rotating wheels.
7. Release the brakes and raise the engine rpm to allow the transmission to perform a 2-3 and 3-4 upshift.
  Did the Input Speed Sensor display an rpm above 7, 700?
  
  Yes
  - Remove the Transmission Oil Pan and inspect for excessive debris such as clutch friction material or metal contamination.
  - Refer to STANDARD PROCEDURE and perform the TRANSMISSION VERIFICATION TEST.
  No
  - Replace and program the TCMA in accordance to the Service Information. Refer to VALVE BODY, REMOVAL .
  - Refer to STANDARD PROCEDURE and perform the TRANSMISSION VERIFICATION TEST.