LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2012 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (3.6L Engine (Service Information)) >> Engine Block >> Seal, Crankshaft Oil, Front >> Installation >> Installation

Seal, Crankshaft Oil, Front: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Front Crankshaft Seal Installer & Oil Seal
GC0144223Courtesy of CHRYSLER GROUP, LLC
  1. Position the front crankshaft oil seal (3) into place on the engine timing cover.
  2. Align the Front Crankshaft Seal Installer (special tool #10199, Installer, Crankshaft Front Oil Seal) (1) to the flywheel key on the crankshaft and against the front crankshaft oil seal (3).
    CAUTION:

    Only tighten the crankshaft vibration damper bolt until the oil seal is seated in the cover. Overtightening of the bolt can crack the front timing cover.

  3. Install and tighten the crankshaft vibration damper bolt (2) until the Crankshaft oil seal is seated in the engine timing cover.
  4. Install the crankshaft vibration damper and accessory drive belt. Refer to DAMPER, VIBRATION, INSTALLATION .
scientia non olet · About LEMON Manuals