LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2012 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (3.6L Engine (Service Information)) >> Cylinder Head >> Camshaft, Engine >> Standard Procedure >> Standard Procedure - Camshaft End Play

Standard Procedure - Camshaft End Play

WARNING: This page is about a different variant/trim than selected.
Fig 1: Measuring Camshaft End Play Using Dial Indicator
GC0144490Courtesy of CHRYSLER GROUP, LLC
NOTE:

Right intake camshaft shown in illustration, other camshafts similar.

  1. Remove the cylinder head cover. Refer to COVER(S), CYLINDER HEAD, REMOVAL .
  2. Mount Dial Indicator Set (special tool #C-3339A, Set, Dial Indicator) (1) to a stationary point at the front of the engine. Locate the probe perpendicular against the nose of the camshaft.
  3. Move the camshaft all the way to the rear of its travel.
  4. Zero the dial indicator.
  5. Move the camshaft forward to the limit of travel and read the dial indicator. Compare the measured end play to the specification. Refer to Engine - Specifications .
scientia non olet · About LEMON Manuals