Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- ACTIVE DTC NOTE:
Diagnose all CAN communication DTCs before continuing.
- Ignition on, engine not running.
- With a scan tool, view DTCs.
Is the status Active for this DTC?
Yes
- Go To 2.
No
- Refer to DIAGNOSIS AND TESTING and perform the Stored Lost Communication DTCs diagnostic procedure.
- COMMUNICATION DTCS PRESENT IN THE TRANSFER CASE CONTROL MODULE
- With a scan tool check for DTCs in the Transfer Case Control Module / AWD.
Are there any CAN bus DTCs active in the Transfer Case Control Module at this time?
Yes
- Refer to DIAGNOSIS AND TESTING and perform the U0102-Lost Communication with Transfer Case Control Module / AWD diagnostic procedure.
No
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Refer to STANDARD PROCEDURE and perform the POWERTRAIN VERIFICATION TEST.
- With a scan tool check for DTCs in the Transfer Case Control Module / AWD.