LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2012 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (6.4L - DTCS P1524 To P2302) >> Diagnosis And Testing >> P2115-Accelerator Pedal Position Sensor 1 Minimum Stop Performance >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different variant/trim than selected.
  1. DTC IS ACTIVE 
    1. Turn the ignition on.
      NOTE:

      This DTC is set when the APPS values are learned in-plant but do not reach the minimum or maximum voltage range.

      NOTE:

      Diagnose any APPS out of range and 5 volt supply DTCs before continuing.

    2. With the scan tool, clear DTCs.
    3. Start the engine.
    4. With the scan tool, select View DTCs.

      Is the status Active for this DTC?

      Yes 

      • Go To  2.

      No 

      • Refer to STANDARD PROCEDURE and perform the INTERMITTENT CONDITION diagnostic procedure.
  2. ACCELERATOR PEDAL POSITION SENSOR 
    1. With a scan tool perform the ETC RELEARN function.
    2. With the scan tool, clear DTCs.
    3. Start the engine.
    4. With the scan tool, select View DTCs.

      Is the status Active for this DTC?

      Yes 

      • Replace the Accelerator Pedal Position Sensor in accordance with the Service Information. After installation is complete, perform the ETC RELEARN function.
      • Refer to STANDARD PROCEDURE and perform the POWERTRAIN VERIFICATION TEST.

      No 

      • Test Complete.
scientia non olet · About LEMON Manuals