Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- ACTIVE DTC NOTE:
Diagnose all CAN B and C communication DTCs before continuing.
- Ignition on, engine not running.
- With a scan tool, view DTCs.
Is the status Active for this DTC?
Yes
- Go To 2.
No
- Perform the Stored Lost Communication DTCs diagnostic procedure. Refer to DIAGNOSIS AND TESTING .
- SAS COMMUNICATION RELATED DTCs IN OTHER MODULES
- With the scan tool, select Network Diagnostics.
Is there more than one module with active DTCs "Logged Against" the SAS at this time?
Yes
- Refer to U0212-00-LOST COMMUNICATION WITH STEERING CONTROL MODULE (SCM) and perform the diagnostic procedure.
No
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
- With the scan tool, select Network Diagnostics.