Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

ACTIVE DTC
NOTE:
Diagnose all CAN B and C communication DTCs before continuing.
1. Ignition on, engine not running.
2. With a scan tool, view DTCs.
  Is the status Active for this DTC?
  
  Yes
  - Go To 2.
  No
  - Perform the INTERMITTENT DTC diagnostic procedure. Refer to INTERMITTENT CONDITION .
TCM COMMUNICATION RELATED DTCs IN OTHER MODULES
1. With the scan tool, select Network Diagnostics.
  Is there more than one module with active DTCs "Logged Against" the TCM at this time?
  
  Yes
  - Replace and program the Transmission Control Module (TCM) in accordance with the service information. Refer to MODULE, TRANSMISSION CONTROL, DESCRIPTION .
  - Perform the NAG1 TRANSMISSION VERIFICATION TEST. Refer to NAG1 TRANSMISSION VERIFICATION TEST .
  No
  - Replace and program the Powertrain Control Module in accordance with the service information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
  - Perform the PCM VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .