Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

PCM ODOMETER MILEAGE NOT PROGRAMMED
1. Turn the ignition on.
2. With the scan tool, attempt to perform the Program PCM Odometer function under the PCM/ECM REPROGRAMMING Procedure. Refer to PCM/ECM REPROGRAMMING - GAS .
3. Using the scan tool, clear DTCs.
4. Start the engine.
5. Allow the engine to reach normal operating temperature.
6. With the scan tool, select View DTCs.
  Is the DTC Active at this time?
  
  Yes
  - Replace and program the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - The SRI mileage has been successfully programmed into the PCM. Test is complete.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .