Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

PROGRAMMING VIN INTO THE PCM
1. Ignition on, engine not running.
2. Using the scan tool, program VIN into the PCM.
3. Start the engine.
  NOTE:
  If the engine will not start, crank the engine over for 15 seconds. Crank at least two times with the ignition switch returning to the off position each time.
4. Allow the engine to reach normal operating temperature.
5. With the scan tool, select View DTCs.
  Does the DTC reset?
  
  Yes
  - Replace and program the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL , also see PCM/ECM REPROGRAMMING - GAS . .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - The VIN has been successfully programmed into the PCM. Test is complete.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .