Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

PROGRAM THE POWERTRAIN CONTROL MODULE
NOTE:
Check the engine for air/vacuum leaks and diagnose any Fuel System Lean/Rich as well as MAP Sensor DTCs before continuing.
1. Verify the PCM is at the latest calibration (flash level).
  NOTE:
  An intermittent loss of power to the PCM without performing an ETC Relearn procedure may cause this DTC to set.
2. Program the PCM in accordance with the Service Information. Refer to PCM/ECM REPROGRAMMING - GAS and follow the procedure .
3. Start the engine.
4. Allow the engine to reach normal operating temperature.
5. Operate the accelerator pedal. (do not exceed 3500 RPM)
6. With the scan tool, select View DTCs.
  NOTE:
  Diagnose any other DTCs that may have set with the P061A.
  
  Does this DTC reset by itself?
  
  Yes
  - Replace and reprogram the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Test Complete.