Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR CURRENT DTC
1. Turn the ignition on.
2. With the scan tool, read PCM DTCs.
  Are any other DTCs present?
  
  Yes
  - Diagnose any other Camshaft Position Sensor DTCs before continuing.
  No
  - Go To 2.
INTERMITTENT WIRING AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
  NOTE:
  Check connectors - Clean/repair as necessary. Poor pin to terminal connections can set DTCs.
  
  Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the wires while checking for shorts and open circuits.
  
  NOTE:
  Check for any Technical Service Bulletins that may apply.
  
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible intermittent condition.