LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2012 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (8HP45 Automatic Transmission (Service Information)) >> Seal, Output Shaft >> Removal >> Rear Wheel Drive

Rear Wheel Drive

WARNING: This page is about a different variant/trim than selected.
Fig 1: RWD
GC0152116Courtesy of CHRYSLER GROUP, LLC
  1. Remove the propeller shaft. Refer to REMOVAL . Move propeller shaft to the right and tie up.
  2. Using a suitable punch, remove the staking from the nut.
  3. Remove the propeller shaft flange nut about using a 34 mm 12 point socket (3) and (special tool #C-3281, Holder, Flange) (2) to hold the flange (1).
  4. Remove the flange (1), and flange dust seal (2).
  5. Remove the output shaft seal (3) with suitable screw and slide hammer.
scientia non olet · About LEMON Manuals