Power Steering Pump - Removal

3.6L ENGINE





1. Remove negative (-) battery cable from battery and isolate cable.
2. Remove cap from power steering fluid reservoir.
3. Using a siphon pump, remove as much power steering fluid as possible from power steering fluid reservoir.
4. Remove accessory drive belt Serpentine Accessory Drive Belt - Removal
5. Raise and support vehicle Maintenance.
6. Remove 3 heat shield mounting bolts (2). Remove heat shield (1) from vehicle.





7. Remove supply hose clamp (1) and remove supply hose from power steering pump fitting.





8. Remove power steering pump pressure hose fitting (2).
9. Remove three pump mounting bolts through pump pulley (not shown in figure).
10. Remove pump (1) (with pulley) from below.
11. If pulley needs removal Power Steering Pump Pulley - Removal.