LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2012 >> 200 S, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lamps/Lighting - Exterior (Service Information) >> Lamp, Fog >> Removal >> Lamp

Lamp, Fog: Removal: Lamp

Fig 1: Fascia, Connector Receptacle, Four Latch Features & Front Fog Lamp Mounting Ring
GC0144672Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Raise and support the vehicle.
  3. Loosen or remove the front lower fascia closeout far enough to access the back of the fog lamp. Refer to FASCIA, FRONT LOWER, CLOSEOUT, REMOVAL .
  4. From behind the front fascia fog lamp bezel (2), disconnect the engine compartment wire harness connector from the front fog lamp bulb connector receptacle (3).
  5. Using a trim stick or another suitable wide flat-bladed tool, carefully pry between the front fog lamp mounting ring (1) and the back of the front fascia fog lamp bezel as necessary to separate the four latch features (4) integral to the back of the fog lamp bezel from the slots in the mounting ring.
  6. Remove the front fog lamp unit from the fascia.
scientia non olet · About LEMON Manuals