Lamp, Fog: Removal: Bulb

CAUTION:

Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.

Fig 1: Fascia Fog Lamp Seat, Connector Receptacle & Front Fog Lamp Housing

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate battery negative cable.
Raise and support the vehicle.
Loosen or remove the front lower fascia closeout far enough to access the back of the fog lamp. Refer to FASCIA, FRONT LOWER, CLOSEOUT, REMOVAL .
From behind the front fascia fog lamp bezel (3), disconnect the engine compartment wire harness connector from the front fog lamp bulb connector receptacle (2).
Firmly grasp the fog lamp bulb on the back of the front fog lamp housing (1) and rotate it counterclockwise about 30 degrees to unlock it.
Pull the bulb straight out from the keyed opening in the housing.