Linkage, Tonneau: Removal: Removal
Courtesy of CHRYSLER GROUP, LLC
- Position the top into the trunk with the tonneau almost fully extended, front bumper not in contact with the decklid.
- Open the decklid into the service position. Refer to STANDARD PROCEDURE
.
- Disconnect and isolate the battery negative cable.
- Using two pocket screwdrivers or similar flat bladed tools, disconnect the right or left control cables from the screw drive assemblies (5). Push screwdrivers into release slots (4) in the screw drive assembly and press inward against cable sleeve. This will release the retaining tabs (1) on the cables allowing them to be pulled out of the screw drive assemblies (5).
Courtesy of CHRYSLER GROUP, LLC
- Mark the tonneau panel to linkage attachment bracket (3) to aid in installation.
- Remove the tonneau cover linkage mounting fasteners (2).
- Slide the linkage to release the retainer and remove the linkage from the decklid.