Seat Cushion Pan - Removal

REMOVAL






NOTE: Power seat shown, manual seat fastening locations similar.

1. Remove the seat from the vehicle,Seat - Removal.
2. Remove the seat back from the seat frame, Front Seat Back Recliner - Removal.
3. Disconnect the heated seat connector, if equipped.
4. Remove the seat wiring harness from the seat pan.
5. Remove four seat pan fasteners (1).
6. Remove the seat pan from the seat adjuster.

NOTE: If replacing the power or manual seat adjuster, remove the track stops from the front of both tracks. These stops need to be removed to snap into the same track locations on the new seat adjuster. If a stop is damaged, a new one should be ordered and installed.