LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 V6-3.6L >> Repair and Diagnosis >> Sensors and Switches >> Sensors and Switches - HVAC >> Refrigerant Pressure Sensor / Switch >> Service and Repair >> A/C Pressure Transducer - Removal

A/C Pressure Transducer - Removal






REMOVAL

NOTE: It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.





1. Disconnect and isolate the negative battery cable.
2. Disconnect the wire harness connector (1) from the A/C pressure transducer (2).
3. Remove the A/C pressure transducer from the A/C liquid line (3) and remove and discard the O-ring seal..

scientia non olet · About LEMON Manuals